Ramsey Winch DODGE GRILL GUARD KIT 295371 (PAT 12/15) User Manual

Page 6

10. Align the mounting kit and tighten all screws to the values

listed in the Torque Value Chart at right. Work from the
bottom of the mounting kit up.

11. Once the mounting kit is tightened up, place the mounting

angle (item #3) between the mounting arm (item #6)
and the vehicle frame. The mounting angle needs to be
snug against both. Clamp the mounting angle and mount-
ing arm together, and mark drill hole locations on the
mounting angle (see figure above).

Drill 0.515” thru holes at the marked locations.

Install the mounting angle to the mounting arm using (2)
1/2-13NC capscrews (item #10), nuts (item #14), and
lockwashers (item #17). Tighten according to Torque
Value Chart above.

Repeat for other side.

12. Refer to Winch Owner’s Manual for instructions on electri-

cal connections. Be sure battery cables are not drawn taut
across any surfaces that could damage them.

13. Push battery cables into loom (item #19) and slide loom

up cables as close as possible to mounting frame assem-
bly. Secure using cable ties at each end of loom. To
improve appearance, wrap ends of loom with electrical
tape.

14. Plug remote switch into female receptacle and confirm

that winch operates. Install cable according to instructions
in Owner’s Manual.

Bolt

Torque,

Size

ft-lbs.

1/4-20

5 ft-lbs

7 Nm

3/8-16

34 ft-lbs

46 Nm

1/2-13

87 ft-lbs

118 Nm

12mm (factory)

39 ft-lbs

54 Nm

Torque Value Chart

Mounting

Arm

Frame

Mounting

Angle