Ramsey Winch DODGE GRILL GUARD KIT 295371 (PAT 12/15) User Manual

Page 2

Note: If the vehicle is equipped with a
diesel engine, raise hood and remove (2)
bolts on the oil cooler. It will be necessary to
lift cooler to allow access to frame and bumper
bolts in the next steps.

If vehicle is not diesel, proceed to step #1.

Note: It is not necessary to remove the airdam in order to modify it or
install the kit.

1. Cut notches in air dam for the Mounting Arms to fit through. Cut 1 3/4” wide

notches from the bottom of the air dam, cutting through the bottom lip of the
air dam. Cut the notches to within 3/16” of the top of the air dam. Do not cut
all the way through the air dam. As shown below, the spacing of the notches
is 18 5/16” from center to outside of notch. One of the clips that holds the air
dam to the bumper should be at the center of the air dam, use it to measure.

The 1 3/4” width of the notch does not allow any clearance of the arm that
fits through it. You may need to trim it slightly after you have the arm
installed, but you will want the fit as tight as possible.

Air dam

Cut Notches

Here

Bumper