Ramsey Winch CHEVY WRAPAROUND KIT 295922 - Manual (Page 6)

5
Step 8
Remove the two nuts #20 that secure the headlight grille to the L.H. wraparound #4. It is not
necessary to remove the capscrews (Figure 18).
Step 9
Note: You will need assistance for this step.
Remove the (3) 3/8-16NC x 1-1/4” capscrews #18 from L.H. side
of center unit where the side plate attaches to the upper support
bracket and the channel (Figure 18).
Have someone position wrap shim #31 between the side plate and
left wraparound #4.
Align the (2) 1/4-20NC x 1-1/4 capscrews #16 holding the
headlight grille to the wraparound with the appropriate holes in the
side plate and slide into place (Figure 19). Secure using (2) 1/4”
nuts #20.
Install (1) ¼-20NC x 1-1/4
capscrew #16 through upper hole
in wraparound and into side plate.
Secure using (1) 1/4” nut #20
(Figure 20). Do not tighten.
Step 10
Re-insert (2) 3/8-16NC x 1-1/4 capscrews #18 through light tube,
shim, side plate, and channel and (1) 3/8-16NC x 1-1/4
capscrews #18 through light tube, shim, side plate, and upper
support bracket and secure all with nut #21 (Figure 21).
Tighten all hardware to proper torque. (See torque value chart,
page 8).
Figure 18
Figure 19
Figure 20
Figure 21