Ramsey Winch CHEVY WRAPAROUND KIT 295922 - Manual (Page 4)

3
Figure 10
Step 4
Note: It is not necessary to remove the vehicle bumper to install this kit.
Install L.H. upper mounting bracket #9 on existing bumper mounting bolt (see Figure 9). Bracket
must be positioned from the top with the two slotted holes pointing toward the center of the vehicle.
Secure using 12 mm nut #19 (see Figure 10). Tighten using a crow’s foot attachment and ratchet.
DO NOT TIGHTEN HARDWARE COMPLETELY.
Install (1) 3/8-16NC X 1” capscrew #13 through 3/8” flatwasher #21, for each of the holes in the
upper support bracket #11, bolting the upper mounting bracket #8 to the upper support bracket #11
so the upper support bracket sits over the vehicle bumper, as shown in Figure 11. Secure using 3/8”
flatwasher #21 and 3/8” nut #17. Figure 12 shows the upper mounting bracket viewed from the top
with the grille removed for clarity.
DO NOT TIGHTEN HARDWARE COMPLETELY.
Figure 9
Figure 11
19
11
9
9
Figure 12