Ramsey Winch CHEVY GRILL GUARD KIT 295369 (PAT 12/15 WINCH) - Manual (Page 5)

10. Install grille tube (Item #5) between mounting arms
(Item #2 and #3). Insert (1 each side) shim (Item
#19) between tube and mounting arm at each end.
Secure using (1 each side) 3/8-16NC X .75 long
capscrew (Item #11) through mounting arm and
into threaded hole in each end of tube.
11. TIGHTEN ALL HARDWARE COMPLETELY. Start at
the grille tube and work down to the mounting chan-
nel tightening all hardware to the appropriate torque
value. (See Torque Value Chart).
12. If needed, install License Tag Bracket
(Item #4) to underside of winch chan-
nel (Item #1) using (2) 1/4-20NC X
1” capscrews (Item #10), (2) 1/4
nuts (Item #12), and (2) 1/4 lock
washers (Item #14). Refer to drawing
at right.
13. Install license tag to License Tag
Bracket using (2) 1/4-20NC X 1/2
capscrews (Item #6). Using (2) 1/4
flat washers (Item #15) if needed for
spacing.
14. Install fairlead using hardware fur-
nished with winch. As shown at right,
note that the mounting bolts should go
through the winch channel and 1/2” holes (turn fair-
lead so that these holes are on top) in roller fairlead.
15. Lift the winch into the winch channel (Item #1).
16. Using hardware supplied with the winch, install four
bolts through bottom of channel and into feet of
winch.
5
11
5
19
2
View from Underside
of Winch Channel
4
10 12 14
6 15
Tip: To orient fairlead,
make sure chamfered
edge is at lower left.
Install bolts through slot in
winch channel, and upper
(1/2”) bolt hole in fairlead.