Ramsey Winch CHEVY GRILL GUARD KIT 295369 (PAT 12/15 WINCH) - Manual (Page 2)

1. Remove the three M12 bolts that secure the vehicle tow
hooks. They are located on either side and on the bot-
tom of the frame (See figures above).
2. Remove the tow hook and the factory hardware and set
it aside.
2
Note: It is not necessary to remove the vehicle bumper to install
this mounting kit.
Note: In two-wheel drive models that do not have front tow hooks, it
will be necessary to cut through bumper for access to frame. From the
underside of the vehicle, mark a starting point from a corner of the end
of the frame. Make a rectangular cut 3.25” wide from the top of the
pocket to the bottom (approximately 3-3.25” high, as shown at right).
The cut does not have to be exact, as the hole will be covered by the
grille guard.
3.25”
~3-
3.25”
CUTOUT FOR TWO-WHEEL DRIVE MODELS
FOUR-WHEEL DRIVE MODELS
(NO CUTOUT REQUIRED)