Ramsey Winch CHEVY GRILL GUARD KIT 295369 (PAT 12/15 WINCH) User Manual

Page 3

Text mode
Original mode

3. Install left mounting arm (Item #2) by inserting it

through the existing tow hook access in the air
dam. The mounting arms should be installed so
that the side plates are on the outside.

4. Install 1/2-13NC X 1-1/4” zinc plate capscrew

(Item #9), lockwasher (Item #16), & flat washer
(Item #17) through bottom hole in frame and into
captive nut in arm. Figure below shows underside
of frame and bracket.

Note: Both zinc plate and black finish 1/2-13NC x
1-1/4” capscrews are supplied in kit. Use zinc
plate in this step, and black finish in step #8.

5. Install 1/2-13NC X 4.5” hex head bolt (Item #7)

through hole in frame (this is where the tow hook
was unbolted in step 1) and through arm #2.
Secure using lockwasher (Item #16) & nut (Item
#13).

6. Install right hand arm following steps 1 through 5 on

right hand side. Do not tighten bolts until winch mount-
ing channel and grille tubes are installed.

13 16