Ramsey Winch RPH-8000 User Manual

Page 15

Before installing motor, check brake adjustment (refer to page 7, ADJUSTING THE
BRAKE).

Place splined end of coupling (item #31), with spirol pin (item #41) installed, inside of
motor end bearing housing (item #7) and slide over splines on end of input shaft. Place
o-ring (item #38) around motor pilot. Mount motor (item #35) to end bearing by aligning
key on motor shaft with keyway in coupling. Be sure that motor mounts flush to end
bearing and that o-ring is set securely in place between motor and end bearing. Secure
motor to end bearing using two capscrews and lockwashers (items #24 & #30). Tighten
capscrews to 49 Ft.Lbs. (66 Nm). Thread plug (item #40) into bottom of brake housing.
Permatex can be added to threads of plug to help in sealing.

Pour a mixture of 1/2 pint (8 oz.) of Mobilfluid 424, Phillips HG Fluid, Texaco TDH, Shell
Oil Co. Donax TD high performance tractor transmission fluid, or equivalent, and 1/4 oz.
of an oil additive (available from the factory) into oil level hole. Oil level should be kept
at oil level hole (plus or minus 1/8"). Thread plug (item #40) into oil level hole. Insert
reducer (item #39) into hole in top of brake housing and breather plug (item #34) into
reducer. Tighten plugs and reducer securely.