Ramsey Winch MINI ROCKER SWITCH REPLACEMENT KIT 256128 - Manual (Page 5)

5
Connect Wiring to Solenoid
C
AUTION
: T
IGHTEN NUTS ON TERMINAL STUDS
TO
35-40
IN
-
LBS
. (3-4 N
M
)
TORQUE
. D
O
NOT OVER
-
TIGHTEN
.
For clarification, see wiring schematic on
page 2.
1. Connect Red Battery Lead (Item #3-3)
between “A” terminal on Solenoid and
positive (+) vehicle battery terminal.
2. Connect Black Motor Lead (item #3-1)
between #2 terminal on motor and C
terminal on solenoid. Connect Black
w/Yellow Stripe Motor Lead (item #3-2)
between #1 terminal on motor and B
terminal on solenoid.
3. Connect Black Battery Lead (item #3-4)
to “E” terminal on Solenoid and route to
negative (-) vehicle battery terminal but
do not connect.
4. Plug black wire from switch into right ter-
minal (terminal above black with yellow
stripe motor lead). Plug Green wire from
switch into left terminal (terminal above
black motor lead).
Finish Installation
1. Confirm that winch clutch is disengaged.
2. Connect negative (-) battery cable to
vehicle battery. Connect Black Battery
Lead from winch to negative (-) vehicle
battery terminal.
3. With ignition switch OFF, press Rocker
switch to “OUT”—winch should not
operate. If the winch does operate with
the ignition off, confirm that proper
accessory wire from ignition was spliced.
4. Spool a few feet of cable out by hand.
Engage winch clutch. Turn ignition switch
ON and press Rocker switch to “OUT”—
winch should spool cable out. If winch
does not operate with ignition on, check
wiring against the schematic on page 1.
5. If winch spools cable IN instead of OUT,
turn off ignition and reverse black and
green wires on solenoid.