Ramsey Winch MINI ROCKER SWITCH REPLACEMENT KIT 256128 - Manual (Page 2)

2
SOLENOID ASS’Y.
BLACK W/ YELLOW
STRIPE MOTOR
LEAD
RED
BATTERY LEAD
BLACK
BATTERY LEAD
BATTERY
BLACK WIRE
BLACK MOTOR
LEAD
GREEN WIRE
RED WIRE
ROCKER SWITCH
#1
MOTOR
#2
NOTE:
TORQUE SOLENOID
TERMINAL NUTS TO
35-40 IN-LBS.
E A
C
B
TO ATV IGNITION
SPLICE
Electrical Schematic
Before Beginning Installation
1. Locate Remote Mounted Switch and
Solenoid and disconnect all wiring to
battery and winch. Switch and Solenoid can
be removed and discarded.
2. Disconnect negative (-) battery cable
from battery. Turn off vehicle ignition.
3. Disengage winch clutch.
4. Remove hood or cowling as necessary for
easier access to installation area.
5. Locate and mark mounting location for
Solenoid Assembly.
6. Locate accessory wire from vehicle ignition
switch that is powered only when ignition is
ON. Use this wire when splicing to Red wire
on Rocker switch.
7. Make sure locations are close enough for
wiring connections to be made without mak-
ing alterations to wire lengths.
C
AUTION
: D
O NOT CONNECT NEGATIVE BATTERY
CABLE OR ENGAGE CLUTCH UNTIL INSTALLATION
IS COMPLETE
. W
INCH COULD BEGIN SPOOLING
CABLE UNEXPECTEDLY CAUSING INJURY OR
DAMAGE TO WINCH
.
IN
OUT
WIRE CONNECTORS