Ramsey Winch RPH-30000 - Manual (Page 13)

12. Align key way of coupling with key on end of input shaft inside end bearing assembly. Slide coupling over
end of shaft. Place gasket (item #33e) into position on motor mounting surface of end bearing (item #9).
Use (2) screws (item #20) to attach adapter plate (item #33d) to motor end bearing. Torque capscrews to
85 ft-lbs. each. Place second gasket (item #33e) on adapter plate. Insert brake shaft with key (item #33c)
into coupling. Re-attach brake (item #33a) to adapter plate using brake assembly screws (item #48).
Torque capscrews to 97 ft-lbs. each.
Note: Care must be taken to assure brake assembly and adapter plate are seated properly prior to install-
ing assembly bolts (item #48). Damage will occur to rotor stack or shaft snap ring if not properly installed.
11
9
7
48
33c
31
33a
33e
33d
33e
20
20
48