Ramsey Winch RPH-25000 QUANTUM W/2-SPD MOTOR - Manual (Page 13)

10
10.Place (2) gear carrier assemblies into ring gear meshing carrier gears with ring gear. Make sure
that ring gear and carrier assemblies are securely against end bearing (item #9). Inspect cover o-
ring for damage and replace if necessary. Attach cover to ring gear. Use (8) capscrews (item
#15) to secure gearbox cover to gear housing end bearing. Torque capscrews to 18 ft. lbs. each,
in criss-cross pattern.
11. Pull rod from air cylinder as far as possible. Slide washer (item #25) over setscrew (item #22)
and against nut attached to air cylinder rod. Place setscrew into hole of shifter shaft (item #12).
Attach new air cylinder (item #30) and gasket (item #33) with sealer, to adapter using (4)
capscrews (item #23). Apply Loc-tite PST thread sealer to threads of capscrews. Torque
capscrews to 5 ft. lbs. each, in criss-cross pattern.
12
9
3
25
33
22
30
23
9