Ramsey Winch RPH-25000 QUANTUM GBX - Manual (Page 15)

12
41
35
43
36
OIL FILL HOLE
9
OIL LEVEL HOLE
14. Apply Permatex to threads of pipe cap (item #43). Thread pipe cap onto pipe nipple in bottom of
gear housing end bearing (item #9). Pour approx. 1.75 pints of SAE 80W-140 oil into end
bearing. Check oil level by removing oil plug noted below. Insert relief fitting (item #35) and
thread reducer (item #41) into end bearing at oil fill hole.
Install winch and connect pressure lines. Apply at least 230 PSI pressure to release brake and
verify that brake releases, by observing that the winch drum rotates.
15. Check proper operation of clutch by applying air pressure to clutch air cylinder to disengage
clutch. Verify that winch freespools. Re-engage clutch. A loud noise should be heard when clutch
engages. Winch drum should not freespool.
16. Operate winch forward and reverse to verify that drum rotates.