Ramsey Winch RPH-25000 QUANTUM GBX - Manual (Page 12)

9
8. NOTE: DETERMINE MOUNTING CONFIGURATION OF WINCH (R.H. or L.H. MOUNTED)
BEFORE ATTACHING FRONT AND REAR FRAME ASSEMBLY TO WINCH, TO ASSURE
PARTS ARE MOUNTED TO PROPER SIDE, REFER TO WINCH MOUNTING
CONFIGURATIONS, STEP 15 PAGE 12.
Seat well-oiled quad-rings (item #38 & #39) into groove of bushing in each end of drum assembly
(item #2), as shown. Carefully set drum assembly (item #2) down over motor end bearing (item
#9). Lift gear-housing end bearing (item #9) and set into place on drum assembly. Install frame
assembly (item #1) using capscrews and lockwashers shown below. Tighten (4) capscrews
securely, check rotation of cable drum.
9. Liberally apply grease to shoulder of input shaft (item #11). Place spring (item #45) over longer
splined end of shaft. Use grease to hold spring in place against shoulder of shaft.
Place spring and shaft through motor end bearing (item #8) and drum until shaft extends through
bushing (item #14) in end bearing (item #9). Place clutch washer (item #27) over splined end of
shaft and against spring. Place end of output coupling assembly (item #7), with longest spline
inward, through end bearing bushing (item #14) and mesh shaft coupling spline with splined end
of shaft. Place short splined end of shifter shaft (item #12) through washer (item #27) and into
shaft coupling (item #6), meshing splines of shifter shaft with splines in shaft coupling. Place
spacer (item #13) over output coupling assembly (item #7).
RING GEAR 24 17
17 24
1
8
38
18 24
18 24
2
9
39
16
45
10
11
8
12
27
7
6
LONGEST SPLINES
9
14
13