Ramsey Winch RPH-15000 (CURRENT) User Manual

Page 9

INSTRUCTIONS FOR OVERHAUL OF RAMSEY WINCH

MODEL RPH 15,000

DISASSEMBLY

Take note of mounting configuration for proper mounting of parts during re-assembly. Replace all gaskets, o-rings,
and seals with new ones during re-assembly.

Disconnect tube (item #44) from elbows
on bottom of brake housing (item #7) and
valve (item #45). Remove motor (item
#31) from brake housing (item #7) by
unscrewing capscrews (item #20). Tap
motor lightly to disengage.

Remove coupling (item #25) from brake
housing. Examine coupling for signs of
wear, replace if necessary. If necessary
remove valve (item #45) from motor by
removing capscrews (item #16) and lock-
washers (item #23). If valve is removed
make sure two square cross section O-
rings remain seated in their counter bores
in valve.

Remove brake housing (item #7) from end
bearing (item #3) by unscrewing (6) cap-
screws (item #20) in a criss-cross pattern
(2 turns each) until all capscrews are
removed from brake housing. Remove brake
parts from brake housing. Examine brake
discs (item #27) for signs of wear and
replace if necessary. Examine O-rings (items
#33 and #34) and backup O-rings (items
#35 and #36)for signs of wear. Remove O-
rings and backup O-rings from grooves in
brake piston (item #4).

Remove and examing springs (items #42
and #43) for damage, replace if necessary.

Examine fitting (item #30) to assure that fit-
tings are in proper working condition, replace
if necessary.