Ramsey Winch RPH-15000 (CURRENT) - Manual (Page 10)

Remove tie plates (item #11) from end bearings (items #3 & #6) by unscrewing capscrews (item #18), as
shown. Slide motor end bearing (item #3) from drum (item #1) and drum from gear housing end bearing (item
#6). Remove input shaft (item #10) and thrust washers (items #47 & #50) from end bearings. Inspect gear teeth
and splined end of shaft (item #10) for signs of wear. If necessary replace shaft.
Remove o-ring (item #37) and bushing (item #14) from outside of motor end bearing (item #3), remove o-ring
(item #32) and bearing (item #13) from inside of motor end bearing. Dip new o-ring (item #32) in oil and seat into
groove inside of end bearing and press new bearing (item #13) into end bearing. Press bushing (item #14) onto
end bearing and dip o-ring (item #37) in oil and seat into groove of end bearing.
Remove seal (item #40) from gear housing end bearing (item #6). Loosen nut (item #22) and remove nylon
setscrew (item #19) and remove ring gear (item #5) from gear housing end bearing. Remove bushing (item #14)
and bearing (item #12) from gear housing end bearing (item #6). Press new bushing (item #14) and bearing (item
#12) into place in end bearing. Install ring gear and nylon setscrew and nut. Ring gear must be fully seated in gear
housing end bearing (item #6)
and slot in ring gear must be
aligned with clutch shifter hole.
Dip new seal in oil and install in
gear housing end bearing, with
sharp edge of seal outward.
10