Ramsey Winch RPH-15000 (CURRENT) - Manual (Page 12)

Set winch on gear housing end with motor end bearing up. Insert (6) springs (item #42) into pockets of motor end
bearing. Install coupling (item #25) over splined end of shaft (item #8). Put (4) brake pins (item #9) into (4) holes
in motor end bearing. Install well-oiled o-ring (items #33 and #34) and backup o-rings (items #35 and #36) into
grooves in O.D. of piston (item #4). Place o-rings into portions of grooves nearest center of piston in both cases.
See Section A-A at right.
Piston (item #4), brake discs (item #27), and separator plates (item #39) must be clean and free of grease and oil.
Place piston over pins (item #9) and on top of springs (item #42). Place separator places (item #39) and brake
discs (item #27) alternately on top of piston, as shown. Press larger diameter end of (4) springs (item #43) into
pockets in brake housing (item #7). Place gasket (item #28) on top of end bearing (item #4). Place brake housing
over brake parts with fitting ports downward toward mounting feet. Align mounting holes and force brake housing
down onto end bearing (item #4). Apply 271 Loc-tite to 6 capscrews (item #17) and finger tighten until flush with
surface of brake housing. Tighten capscrews (2 turns each) in a criss-cross pattern until a torque of 30 ft-lbs. for
each capscrew is achieved.
12