Ramsey Winch RPH-10000 - Manual (Page 14)

11
Remove o-ring (item #36) and bushing (item #15) from motor end bearing (item #7). Press
new bushing onto end bearing and dip o-ring in oil and seat into groove of end bearing.
Remove seal (item #45) from gear housing end bearing (item #8). Loosen nut (item #27)
and remove nylon setscrew (item #22) and remove ring gear (item #6) from gear housing
end bearing, if necessary. Remove bushing (item #16) from gear housing end bearing (item
#8). Press new bushing (item #16) into place in end bearing. Install ring gear and nylon
setscrew and nut. Ring gear must be fully seated in gear housing end bearing (item #8) and
slot in ring gear must NOT be aligned with clutch shifter hole. Install new seal in gear
housing end bearing, with sharp edge of seal outward.