Ramsey Winch RPH-10000 - Manual (Page 12)

9
Remove tie plates (item #13) from end bearings (items #7 & #8) by unscrewing capscrews
(item #18), as shown. Slide motor end bearing (item #7) from drum (item #1) and drum
from gear housing end bearing (item #8). Remove input shaft (item #12) from end bearing.
Inspect teeth of gear (item #5) for signs of wear. If necessary replace gear by removing
snap ring (item #47) and thrust washer (item #50). Slide new gear over splines of shaft
and against snap ring on shaft. Re-install thrust washer and place snap ring into groove of
shaft.