Ramsey Winch HD-P8000 914178-0209 - Manual (Page 11)

9
Remove tie plates (items #11) from end bearings by unscrewing capscrews (items #15). Slide motor end bearing
(item #8) and drum (item #1) from gear housing end bearing.
Remove input shaft (item #10) from end bearing. Inspect shaft and and output sun gear (item #7) for damage and
replace if necessary. To remove the output sun gear, remove the snap rings (items #38) and thrust washer (item
#44) and pull off the end of the shaft.
Remove bushing (item #13) and o-ring (item #34) from motor end bearing. Place new, well-oiled o-ring into groove
inside of end bearing and press new bushing onto end bearing.
13
34
8
38
44
7
10 1
11
15
11
15
Remove seal (item #37) from gear housing end bearing (item
#9). Loosen nut (item #20) and remove nylon setscrew (item
#17). Remove ring gear from gear housing end bearing, if nec-
essary. Remove bushing (item #12) from end bearing.
Press new bushing into end bearing. Install ring gear, then
nylon setscrew and nut. Ring gear must be fully seated in end
bearing and slot in ring gear MUST NOT be aligned with clutch
shifter hole. Install new seal in end bearing, with sharp edge of
seal outward.
12 9
26
37
20
17