Ramsey Winch HD-P8000 914184-0209 - Manual (Page 12)

10
Set winch with gear housing end down on work surface.
Install well-oiled o-rings and backup rings into grooves on outside of brake piston and backup brake pis-
ton as shown in cross-section A-A below.
Piston, backup piston, brake discs and stators must be clean and free of grease and oil.
Insert brake discs (item #7) and stators (item #6) into gear end alternating, with stators first and last.
Insert backup brake piston (item #9) into motor end and insert brake piston (item #8) into it. Apply
even pressure on piston when installing.
Install retaining rings (item #46 and #47) into grooves in motor end housing.
7
6
39
37
9
35
40
36
38
8
46
A
A
SECTION A-A
8 9
38 36 37 39
35
40
MOTOR SIDE
DRUM SIDE
47