Ramsey Winch HD-P 177,9 - Manual (Page 10)

7
5. Remove clutch housing #27 with piston #28 inside. To remove piston from clutch housing apply air to 1/8” port. Remove o-
rings #28 and #35 and inspect for damage or wear.
6. Remove (9) springs #39, thrust washer #26, gasket #31, output shaft #12 and spacer #13 from gear end bearing. In-
spect output shaft bushing #14 for damage or wear. Replace if damaged or excessive wear.
36
28
35
27
13
12
26
14
31
39