Ramsey Winch HD-P8000 FOR NRC - Manual (Page 9)

INSTRUCTIONS FOR OVERHAUL HD-P8000 SERIES WINCH
Take note of mounting configurations for proper mounting of parts during re-assembly. Replace all gas-
kets, o-rings, and seals during re-assembly.
Disconnect tube (item #41) from elbow fittings (items #24) on bottom of end bearing and counterbalance valve
(item #42). Remove motor (item #27) from end bearing by slowly unscrewing capscrews (items #18). CAUTION:
MOTOR IS UNDER SPRING PRESSURE.
Check breather vent (item #45). Make sure it is not clogged. If oil is leaking from vent, check brake o-rings, backup
rings, and sealing surfaces (see page 8).
Remove springs (items #40) from pockets and inspect for damage.
Replace gasket (item #25).
Remove coupling (item #23) from end bearing. Examine coupling for signs of wear, replace if necessary. If neces-
sary, remove counterbalance valve from motor by removing capscrews (items #14).
7
40
24
41 42 21
14
24
23
25
27
22
18
35
45