Ramsey Winch HD-P40000 W/TNR & 2 SPEED MOTOR User Manual

Page 5

914243-0711-D

WINCH OPERATION

The best way to get acquainted with how your winch operates is to make test runs before you use it. Plan
your test in advance. Remember, you hear your winch, as well as see it operate. Learn to recognize the
sounds of a light steady pull, a heavy pull, and sounds caused by load jerking or shifting. Gain confidence in
operating your winch and its use will become second nature with you.

The uneven spooling of cable, while pulling a load, is not a problem, unless there is a cable pileup on one end
of drum. If this happens, reverse the winch to relieve the load and move your anchor point further to the cen-
ter of the vehicle. After the job is done you can unspool and rewind for a neat lay of the cable.

CLUTCH OPERATION

To engage clutch:

1. Move the clutch control valve to the “clutch engaged” position.

2. Anytime the temperature is below freezing, run the motor in the “cable out” direction only until the

drum starts to turn. In extreme cold temperatures (below 0

˚ F/-18˚ C), pull out on the cable by hand

only until the drum starts to turn.

3. Wait at least 3 seconds for the clutch to fully engage, after which the winch is ready to winch in the

cable.

WARNING: Do not attempt to engage the clutch by first running the winch motor and then moving the
clutch control valve to the "clutch-engaged" position while the motor is running. Do not start picking up

the load at the same time the clutch is being engaged.

To disengage clutch:

1. Run the winch in the "cable out" direction until the load is off the cable.

2. Move the clutch control valve to the "clutch-disengaged" position.

3. The cable may now be pulled off by hand.

CABLE INSTALLATION

1. Unwind cable by rolling it out along the ground to prevent kinking. Securely wrap end of wire rope, op-

posite hook, with plastic or similar tape to prevent fraying.

2. Insert the end of cable, opposite hook end, into the hole in drum barrel. Secure cable to drum barrel,

using setscrew furnished with winch. TIGHTEN SETSCREW SECURELY.

3. Carefully run the winch in the “reel-in” direction. Keeping tension on end of cable, spool all the cable

onto the cable drum, taking care to form neatly wrapped layers.