Ramsey Winch HDP35000 - Plantetary Industrial Winch - Manual (Page 4)

WARNINGS:
CLUTCH MUST BE TOTALLY ENGAGED BEFORE STARTING THE WINCHING OPERATION.
DO NOT START WINCH MOTOR BEFORE ENGAGING CLUTCH.
DO NOT DISENGAGE CLUTCH UNDER LOAD.
STAY OUT FROM UNDER AND AWAY FROM RAISED LOADS.
STAND CLEAR OF CABLE WHILE PULLING. DO NOT TRY TO GUIDE CABLE.
DO NOT EXCEED MAXIMUM LINE PULL RATINGS SHOWN IN TABLE.
DO NOT USE WINCH TO LIFT, SUPPORT, OR OTHERWISE TRANSPORT PEOPLE.
A MINIMUM OF 5 WRAPS OF CABLE AROUND THE DRUM BARREL IS NECESSARY TO HOLD
THE LOAD.
CABLE ANCHOR IS NOT DESIGNED TO HOLD LOAD.
Weight (without cable)...............................................................................504 lb. (229 Kgs.)
Rated Line Pull (lbs.)...................................................................................................35,000
12,970
16.46
28,600
Gear Reduction..........................................................................................................33.16:1
Rev. motor at 2725 psi working pressure.
* These specifications are based on recommended wire rope .75" dia. EIPS and 11.9 cu.in./
(Kgs.)......................................................................................................15,909
1 2 LAYER OF CABLE
*Line speed (high)
*Cable capacity
(at 25 GPM)
per layer
*Rated line pull
FPM
Kg.
Lbs.
MPM
M.
Ft.
6.09 13.72
14.02
46 56
15,870
35,000
20 45
3 4 5
9,520
33.53
72
21,000
110
21.34
22.86
64
19.46
10,970
24,200
75
47.24
82
25
8,390
18,500
155
12.50
41
10.67
36
9.73
32 27
8.23
23
7.01 MPM
FPM
(at 25 GPM)
*Line speed (low)
* Directional control valve required: 3-position, 4 way motor spool.
* Winch meets SAE J706.
46
14.02
200
16,500
7,484
28.04
92
60.96
6
Continued
1a
SPECIFICATIONS* SHORT DRUM