Ramsey Winch HDGY-350R W/4.5 CID MOTOR - Manual (Page 10)

8
9. Examine shifter assembly #1 for damage
to yoke. Yoke should be firmly attached to
shaft, yet able to swivel freely around shaft.
Replace if necessary.
Install new shifter assembly #1 by placing
end of shaft, opposite yoke, through spring
#45 and into housing #12.
10. Check cover bushing #17 for signs of
wear. If necessary remove old bushing
and press bushing into place.
11. Apply grease to end of shaft, opposite
gear. Apply grease to bushing in gear
housing #11. Place greased end of shaft
through thrust washer #47 and bushing in
gear housing #11. Place gasket #31 onto
gear housing cover #7. Apply grease to
gear end of shaft and cover bushing. Place
cover onto shaft and secure to housing
with ten #19 capscrews. Tighten
capscrews to 8 ft. lbs. (10.8 Nm) each.
12. Press bearing #16 onto worm #15.
NOTE: Be sure that thick shoulder of
bearings outer race (side with
manufacturer's name and part number) is
out, away from worm threads. Press
bearing and worm into gear housing. Slip
new gasket #30 onto brake housing. Use
four capscrews #22 to secure brake
housing to gear housing. TIGHTEN
CAPSCREWS TO 8 FT. LBS. (10.8 Nm.)
EACH. See re-assembling and checking
the brake on page 13 to complete brake
assembly.