Ramsey Winch HDG-350 LEVER EQUIPPED User Manual

Page 7

TROUBLE SHOOTING GUIDE
CONDITION POSSIBLE CAUSE CORRECTION

Clutch inopera

Ɵve 1. Dry or rusted shaŌ. 1. Clean and lubricate.

or binds up. 2. Bent yoke or linkage. 2. Replace yoke or sha

assembly.
3. Clutch jaws are in contact. 3. See Techniques of
Opera

Ɵon

Oil leaks from 1. Seal damaged or worn. 1. Replace seal.
housing 2. Too much oil. 2. Drain excess oil. Refer to
Techniques of Opera

Ɵon.

3. Damaged gasket. 3. Replace gasket.

Winch runs 1. Hydraulic motor worn out. 1. Replace motor.
too slow 2. Low

Ňow rate. 2. Check Ňow rate. Refer to

Hydraulic Systems

Ňow

chart, page 4.

Cable Birdnests 1. Drag brake disc worn. 1. Replace discs.
when clutch is
disengaged.

Hydraulic

Ňuid 1. Hydraulic motor shaŌ seal 1. Replace seal.

leaks out hole in damaged.
motor adapter

INSTRUCTIONS FOR OVERHAUL OF HDG-350
DIS-ASSEMBLY

Drain oil from gear housing by

removing #40 plug from bottom of

gear housing. Remove plugs #38 &

#39 from top of gear housing.

Remove mounting angles from

winch by removing hardware shown.