Ramsey Winch HDG-350 LEVER EQUIPPED - Manual (Page 10)

8
11. Apply grease to end of shaft, opposite gear.
Apply grease to bushing in gear housing #8.
Place greased end of shaft through thrust
washer #48 and bushing in gear housing #8.
Place gasket #34 onto gear housing cover #4.
Apply grease to gear end of shaft and cover
bushing. Place cover onto shaft and secure to
housing with ten #23 capscrews. Tighten
capscrews to 8 ft. lbs. (10.8 Nm) each.
1 2. Press bearing #19 onto worm #16. NOTE:
Be sure that thick shoulder of bearings outer
race (side with manufacturer’s name and part number)
is out, away from worm threads.
Press bearing and worm into gear housing. Slip new
gasket #33 onto brake housing. Use four capscrews
#25 to secure brake housing to gear housing.
TIGHTEN CAPSCREWS TO 8 FT. LBS. (10.8 Nm.)
EACH. See re-assembling and checking the brake on
page 13 to complete brake assembly.
13. Press bearing #19 onto worm and into housing. NOTE:
Be sure that thick shoulder of bearings outer race (side
with manufacturer’s name and part number) is out,
away from worm threads. Place gasket #33 onto
adapter #1. Attach adapter to gear housing using four
(4) capscrews #26. TIGHTEN CAPSCREWS TO 12
FT. LBS. (16.3 Nm.) EACH. Insert keys #11 into
keyways of worm shaft. Slide tapered end of coupling
#3 over end of worm shaft. Be sure roll pin #41is in
coupling.
Place motor shaft, with key in keyway, into coupling.
Secure motor to adapter, using two (2) capscrews #27
and lockwashers. TIGHTEN CAPSCREWS TO 75 FT.
LBS. (102 Nm.) EACH.
RE-ASSEMBLY
14. Place winch with gear housing cover down on work
bench. Drum shaft should be in vertical position. Slide
thrust washer #47 over drum shaft and slide downward
until washer rests on gear housing. Set springs #46 into
pockets of gear housing with drag brakes #32 on top of
springs. Slide drum assembly #5 onto drum shaft with
drum jaws upward.