Ramsey Winch DCS-200 SPEED REDUCER - EZ ANCHOR - Manual (Page 6)

CONDITION CORRECTION POSSIBLE CAUSE
6
OIL LEAKS FROM HOUSING
1. Seal damaged or worn.
2. Too much oil
3. Damaged
gasket
1. Replace seal.
2. Drain excess oil. Refer to
TECHNIQUES OF OPERA-
TION.
3. Replace gasket.
MOTOR RUNS IN ONE
DIRECTION
1. Jar solenoid to free contacts.
Check by applying 12 volts to
coil terminal (it should make an
audible click when energized).
2. Disengage speed reducer
clutch or remove armature
lead. Remove switch plug
from hood. Raise connec-
tor cover on hood and with
a screw driver, short the
bottom two pins. Solenoid
should click. Short the two left
hand pins. The other sole-
noid should operate. If both
solenoids operate check for a
broken wire in switch cable.
3. Check for loose connection on
switch and switch connector.
1. Inoperative solenoid or
stuck solenoid.
2. Inoperative switch.
3. Broken wire or bad con-
nection.
MOTOR RUNS, BUT OUT-
PUT SHAFT DOES NOT
TURN. 1-3. It will be necessary to
disassemble speed reducer
to determine cause and
repair.
1. Sheared drum shaft
key.
2. Stripped bronze
gear.
3. Parted shaft.
TROUBLE SHOOTING GUIDE