Ramsey Winch TRIPLE X - Manual (Page 8)

Operating Instructions
The winch clutch allows rapid unspooling of the rope for
hooking onto the load or anchor point. The clutch is
operated by the shifter knob located on the gear housing
end of the winch as follows:
1. To disengage the clutch, move the clutch shifter knob
to the “OUT” position. Rope may now be freespooled
off the drum.
2. To engage the clutch, move the clutch shifter knob
into the “IN” position. The winch is now ready for
pulling.
MAINTENANCE
All moving parts are permanently lubricated with high
temperature lithium grease at the time of assembly.
Under normal conditions factory lubrication will suffice.
Corrosion on electrical connections will reduce perform-
ance or may cause a short. Clean all connections
especially in remote control switch and receptacle. In
salty environments use a silicone sealer to protect from
corrosion.
To minimize corrosion of the internal motor components
that may occur due to condensation, power the winch in
or out periodically. Energizing the motor will generate
heat, which will help dissipate any moisture buildup in
the motor. This should be performed at periodic intervals
(such as with each oil change of your vehicle). Note:
Refer to the Troubleshooting Guide if the motor has been
submerged.
Rope Maintenance
The most important part of maintenance of the synthetic
rope is to inspect it regularly. Any time the winch is
used, the synthetic rope should be inspected thoroughly
as described on page 11.
Likewise, inspect the protective sleeve and replace if it
becomes torn, fused, or threadbare.
Keep the rope and protective sleeve free of moisture,
grease, dirt or other debris. If necessary, clean with a
damp cloth.
8