Ramsey Winch TRIPLE X User Manual

Page 10

Replacement Rope Installation

Notes:

· Rope should be installed so that it feeds from the bottom of the drum. Rope anchor should be installed

on the motor end drum flange, as shown below.

· An Aluminum Hawse Fairlead, P/N 251267 (included with winch), is required for use with the Ramsey

Synthetic Rope.

· Before installing synthetic rope, inspect winch drum and fairlead and smooth any sharp edges on drum

barrel, flanges and other winch accessories that may contact the rope.

1. Unwind new rope by rolling it out along the ground.

2. Remove existing rope, noting how it is installed in the drum.

3. Rotate drum to locate existing hole in flange that is closest to

the drum barrel.

4. Feed synthetic rope through aluminum hawse fairlead and

under drum. See figure page 4.

NOTE: Install rope anchor into hole in flange on motor end of drum only.

5. Insert synthetic rope
anchor into hole in flange
closest to drum barrel.

6. Carefully run winch in the “reel-in” direction. Wear gloves and use the hook strap, keep tension on end of rope as

you spool all the rope onto the drum, taking care to form neatly wrapped layers.

Pull synthetic rope tight to seat
anchor in hole.