Ramsey Winch PATRIOT PROFILE 9500 UT - Manual (Page 5)

5
2 1 A
View A-A
A
A
To mount Solenoid Assembly, use in-
cluded Solenoid mounting Bracket.
Mount bracket to tie bar using (1) ¼-
20NC x 1” capscrew in place of ¾” tie
bar capscrew. Install bracket to back of
solenoid using included nuts and lock-
washers.
When mounting winch, connect labeled
motor leads coming from solenoid as-
sembly to appropriately marked motor
terminals as shown lower right. Tighten
nuts on motor terminals securely.
Attach solenoid ground wire to ground
bolt located on bottom of motor (Bat-
tery ground wire is already installed to
grounding bolt on motor).