Ramsey Winch PATRIOT PROFILE 9500 UT - Manual (Page 4)

4
CLUTCH
SHIFTER LEVER
CHANNEL
MOUNTING
ROLLER
FAIRLEAD
1/2" DIA.
7/16" DIA.
OF FAIRLEAD TO THE DRUM, USE
**TO ENSURE PROPER ALIGNMENT
THE SMALLER DIA. SET OF HOLES
FOR MOUNTING.
3/8-16NC X 1-1/4" LG.
WINCH MOUNTING BOLT
FAIRLEAD MOUNTING BOLT
3/8-16NC X 1-1/4" LG.
Installation
The winch shown in this owner’s manual is solely and ex-
clusively designed for vehicle mounted, non-industrial appli-
cations. All other applications will void warranty.
It is very important that the winch be mounted on a flat sur-
face so that the three major sections (the motor end, the
cable drum, and the gear housing end) are properly aligned.
It is recommended that Ramsey kits be used to mount the
winch. They are designed to align the winch and distribute
up to the full rated load evenly, to avoid possible damage to
the winch or vehicle.
NOTE: If recommended mounting is not used, a kit of equal
design must be used.
Also available for mounting the Patriot Profile 9500 UT are
the following winch mounting channels:
• #251126 short length (23.63”) black
• #251127 medium length (30.00”) black
• #251128 long length (36.00”) black
It is recommended that Ramsey mounting channels be used
with all non-Ramsey mounting.
Attach fairlead to channel using hardware furnished with
winch. Attach winch to channel. Thread capscrews with
lockwashers through mounting holes in channel and into
winch feet (see Figure 1).
Substitution of attaching hardware items (bolts, nuts or
washers) different from those supplied with your winch and
mounting kit can lead to failure causing damage or serious
injury (use SAE grade 5 bolts or better and torque to 34
ft.lbs.).
Place end of wire rope through fairlead and attach cable
hook. Use clevis pin and cotter pin (see Figure 1).