Ramsey Winch SAFETY ON_OFF SWITCH KIT 282062, 282063 - Manual (Page 4)

2
3
2
1
5 amp
BLACK (#1c)
RED (#1b)
YELLOW (#1a)
WIRE SPLICE
GROUND
RED (TO WINCH
POWER)
BLACK (#1d)
RED (#1e)
TO VEHICLE
IGNITION
Switch Installation
1. Drill (2) 5/32” (4mm) holes 9/16” (14mm) apart for the switch mounting panel (item
#4). The slots at the top or bottom of the mounting panel can also be used as a guide.
2. Install the mounting panel using (2) #10 self-tapping screws (item #2f) through the
slots of the panel.
Snap the switch (item #5) into the mounting panel after the switch wires are plugged
into it.
Wiring Installation
D
O NOT CONNECT NEGATIVE BATTERY CABLE OR ENGAGE CLUTCH UNTIL INSTALLATION IS COM
-
PLETE
.
M
AKE SURE WIRES ARE NOT DRAWN TAUT ACROSS ANY SURFACES THAT COULD DAMAGE THEM
.
T
IGHTEN NUTS ON LARGE SOLENOID TERMINAL STUDS TO
35-40
IN
-
LBS
. (3-4 N
M
)
TORQUE
.
D
O NOT OVERTIGHTEN
.
BLACK (FROM
WINCH GROUND)
FUSE
SWITCH
SOLENOID
BATTERY
Rocker switch
in OFF position