Ramsey Winch ATV-3000 W_MINI ROCKER SWITCH - Manual (Page 5)

3. Remove the bolts that hold the end plate to
the motor end housing. Lift off the end plate
and take the nuts and washers out of the
mounting feet. Set aside the gear assem-
blies and bushing. The input sun and plane-
tary gear carrier may come out together.
4. Lean the motor end and loosen the motor tie
bolts off the tie bolt nuts. Lean the motor
end back up so that it is sitting upright. Do
not let the motor end cap come apart
from the rest of the motor. Lift the motor
end housing and rotate 90°. Put the tie bolt
nuts in the other set of pockets and carefully
lean the motor end back. Tighten the tie
bolts to 45-50 in-lbs. torque. Do not over-
tighten.
5. After rotating the motor, the motor end will
appear as shown at right. The motor studs
will be aligned horizontally, and the motor tie
bolt nuts will be in the other set of pockets.
5