beautypg.com

Powermate PM0135500 User Manual

Page 17

background image

APPLYING LOAD

This unit has been pretested and adjusted to handle its full

capacity. Before starting the generator, disconnect all load.

Apply load only after generator is running. Voltage is

regulated via the engine speed adjusted at the factory for correct

output. Readjusting will void warranty.

STOPPING THE GENERATOR
1. Before stopping the engine, make sure all electrical loads

are unplugged from the panel.

2. Let the engine run for two minutes without load.
3. Move the key switch to the “OFF” position.
4. Do not leave the generator until it has completely

stopped.

5. Turn off the Propane cylinder fuel valve.
6. If a cover is used, do not install until unit has cooled.
7. If the generator will not be used again for an extended

time period, refer to the SERVICE AND STORAGE

section of this manual.

17

Customer Hotline 1-800-445-1805

Provide adequate ventilation for toxic exhaust gases and

cooling air flow.

Do not start or run the generator in an enclosed area,

even if door or windows are open.

Engines give off carbon monoxide, an odorless, colorless,

poison gas.

Breathing carbon monoxide can cause nausea, fainting or

death.

When applying a load, do not exceed the maximum wattage

rating of the generator when using one or more receptacles.

Also, do not exceed the amperage rating of any one

receptacle.

Do not apply heavy electrical load during break-in period (the

first two to three hours of operations).

English

Allow generator to run at no load for two minutes upon each

initial start-up to permit engine and generator to stabilize.