Pvm - pg12 – Poly-Tex Poly-Vent (Retrofit) User Manual

Page 12

INSTRUCTIONS:

IMPORTANT NOTE: ALL FASTENERS MUST BE INSTALLED
WITH THE BOLT HEAD ON THE INSIDE OF THE POLY-VENT
FRAME TO PREVENT DAMAGE TO THE POLY-VENT TUBES.

3A. INSTALL THE REAR PANEL. THE TOP OF THE

REAR PANEL MOUNTS OUTSIDE OF THE
BACKER PLATE TOWARDS THE INSIDE OF THE
STRUCTURE ON THE TOP. SLIDE THE BOTTOM
OF THE REAR PANEL BETWEEN THE BOTTOM
GUTTER AND THE RAIL (OR THE SKIRTING IF
SKIRTING IS USED). MOUNT THE TOP OF THE
PANEL FIRST, USING HARDWARE PROVIDED.
DO NOT USE THE FIRST MOUNTING HOLE. IT
WILL BE USED LATER TO MOUNT THE END
PANEL. ONLY FINGER TIGHTEN HARDWARE
AT THIS POINT.

3B. MOUNT THE BOTTOM OF THE REAR PANEL. DO

NOT USE THE FIRST MOUNTING HOLE. IT WILL BE
USED LATER TO MOUNT THE END PANEL. THE
HARDWARE FOR MOUNTING THE BOTTOM EDGE
OF THE REAR PANEL IS NOT INCLUDED. THE
INSTALLER MUST PROVIDE THE NECESSARY
HARDWARE.

3C. INSTALL FRONT PANEL. MOUNT THE TOP OF THE

PANEL FIRST USING HARDWARE PROVIDED.
MOUNT THE TOP OF THE PANEL ON THE INSIDE OF
THE TOP GUTTER'S FRONT FLANGE. DO NOT USE
THE FIRST MOUNTING HOLE. IT WILL BE USED
LATER TO MOUNT THE END PANEL. ONLY FINGER
TIGHTEN HARDWARE AT THIS POINT.

3D. MOUNT THE BOTTOM OF THE FRONT PANEL. THE

BOTTOM EDGE OF THE FRONT PANEL MOUNTS TO
THE OUTSIDE OF THE BOTTOM GUTTER. DO NOT
USE THE FIRST MOUNTING HOLE. IT WILL BE USED
LATER TO MOUNT THE END PANEL. ONLY FINGER
TIGHTEN HARDWARE AT THIS POINT.

FLARED EDGE
FLARES AWAY
FROM THE
POLY- VENT
FILM ON BOTH
FRONT AND
REAR PANELS.

REAR PANEL

MOUNTS BEHIND

BACKER PLATE

FRONT PANEL

MOUNTS ON THE

INSIDE OF THE TOP

GUTTER'S FRONT

FLANGE

REAR PANEL

MOUNTS BEHIND

BOTTOM GUTTER.

BOTTOM EDGE OF FRONT PANEL
MOUNTS TO THE OUTSIDE OF THE
BOTTOM GUTTER.

1/4" LOCK WASHER
1/4" HEX NUT
1/4" x 3/4" HEX BOLT (INSIDE)

DO NOT USE FIRST MOUNTING

HOLE AT THIS POINT.

DO NOT USE FIRST

MOUNTING HOLE AT

THIS POINT.