Otter Outdoors Pro XT 1200 Cabin - Manual (Page 5)

Page 5
7. Position sled (Item 1) as shown in Diagram 7, with curved front to your left. Using front drilling pattern (on
back page) mark two holes for the front frame bracket with a sharp object. Using rear drilling pattern (on back
page), repeat this step for the rear frame bracket.
8. Drill the 4 marked holes using a 5/16 bit.
9. Drill the 3/8 in. hole in center of lip approximately 16 inches from bend in sled. The back wind support bar
(Item 5) is to be propped here.
Diagram 7
Diagram 8
Item 25 - 5/16 Washer
Item 28 - 1/4 Nylon Hex Lock Nut
10. Bolt frame brackets (Item 3 and Item 4) to sled using holes predrilled in Step 8.
Use appropriate fasteners shown in Diagram 8.
Place front and rear drilling
patterns in these corners.
16 in.
3/8 in.
Hole
1
3
25
28
4
Seat assembly not shown for clarity.