Otter Outdoors Pro XT 1200 Cabin - Manual (Page 2)

Page 2
2. Place the seat rail bracket (Item 20) on the first hole and mark second hole location. Note: Bracket for front of
sled has a different bend then the rear of sled. Drill the remaining two 5/16” holes through the sled. Do not attach
the brackets to the sled at this point. Ref. Diagram 2.
Diagram 2
1. Position sled as shown in Diagram 1 with curved front to your left. Measure 17” from the front/left corner of the
sled and 7/8” down and mark the location for the top hole needed for the seat rail bracket (Item 20). Measure 17-
1/2” from the rear/left corner of the sled and 7/8” down and mark the location for the top hole needed on the other
side. Check bracket placement to be sure brackets are either flush with top edge of sled or below the edge
approximately 1”. Drill the two 5/16” holes through the sled. Ref. Diagram 1.
Diagram 1
20
Front
17 in.
7/8 in.
7/8 in.
17-1/2 in.
Note: This location may be
marked at 1-3/4” for a slightly
lower seating position.
Rear
Mark second hole and drill 5/16”
Front of sled
bracket
Rear of sled
bracket
Right
Left
First hole
Tools Required:
7/16” Box End Wrench 3/8 Bit
7/16” Socket and Ratchet 5/16 Bit
Drill/Driver
Phillips Bit
Complete Pkg Only
1/2” Wrench
1/2” Socket