Otter Outdoors Pro XT 1200 Cabin - Manual (Page 10)

Page 10
19. Slide the tent over the main frame bar assembly, then fasten the velcro straps on the inside of the tent to each
main frame bar. Note: Collapsing the center and front main frame poles part way down will make installation
easier. Ref. Diagram 17.
Tent
Main Frame
Assembly
Diagram 17
20. The canvas tent (Item 2) has a plastic trim seal sewn into the edge, snap the plastic trim seal to the edge of the
sled (Item 1). Start at the front left corner and work your way around across the back and up the opposite side.
Ref. Diagram 18.
Optional: Secure with extra self-tapping screws if needed. See Detail A. Ref. Diagram 18.
Diagram 18
Back
Left Side
Front
Right Side
Line up seam on the corner
Left Side Back
1
2
Detail A
Trim seal
Self-tapping screw
Optional Step
32