ODL Sliding Patio Doors with Blinds Between Glass - Manual (Page 4)

INSTALLATION INSTRUCTIONS
for Doors with Integral Nailing Fin (JII006-ODL)
4
b. Adhere the
pieces of
flashing to the
inside corners.
5. Smooth gaps or
bubbles beneath
self-adhesive
flashing with a
J-roller (remove
and replace if
necessary).
INSTALL SILL PAN
1. place the sill pan in
the rough opening.
2. Apply spray
adhesive/primer to
the sill area. Follow
manufacturer's
instructions
for application
methods.
3. Cut a piece of self-
adhesive flashing
the length of the sill
and apply over the
sill pan as shown.
The bottom of the
sill pan should be
completely covered
by the self-adhesive
flashing.
6. seal back corners
of sill pan with
sealant.
7. For step-down
landings only, cut
plastic drain screen
to length of
sill + 2" and staple
1/2" below sill
edge. The drain
screen provides
a path for air to
dry any incidental
moisture in the
rough opening.
8. For continuous
slab landings only,
remove nailing fin at sill.
9. Apply a 3/8" continuous bead of sealant across the sill pan back
dam.
10. Tilt patio door into the rough opening. make sure the back of the
door makes solid contact with the sealant. Adequately support the
door until fully installed.
Spray Adhesive
6"
3"
4. Cut two pieces
of self-adhesive
flashing 6" wide
and the sill pan
width + 3" long.
a. For continuous
slab landings
only, cut out the
inside corner.
sill
pan
width
6"
3"
Discard
(for
continuous
slab only)
Self-Sealing Corner Flash
sill
pan
width
3"
6"
Discard
(for
continuous
slab only)
sill pan
width
3"
3"
Continuous Slab Landing
sill pan
width
3"
3"
Step-Down Landing
sill pan
width
3"
3"
sealant
1"
1/2"
4
prepAre rOuGh OpeNING - CONTINueD