Axis Communications Fixed Dome Network Camera AXIS P3301-V - Manual (Page 5)

5
AXIS P3301/-V - Product overview
Microphone - built-in microphone. This can be disabled by inserting a plug in the 'Audio in' connector.
Power Connector - for connection of the PS-H power adapter (included).
I/O Connector - the I/O terminal connector provides the physical interface to one transistor output, one digital input and an
auxiliary connection point for DC power. For more information, see The I/O Terminal Connector, on page 33.
Network Connector - The camera connects to the network via a standard network connector. Supporting NWay, the camera
detects the speed of the local network segment (10BaseT/100BaseTX Ethernet). Supporting PoE (Power over Ethernet), the
camera can be powered directly from the network cabling.
Audio Out - audio output (line level), which can be connected to a public address (PA) system or an active speaker with a
built-in amplifier. A pair of headphones can also be attached. A stereo connector must be used for the audio out.
Audio In - a 3.5 mm input for a mono microphone, or for a line-in mono signal (a stereo signal from line-in uses the left
channel).
Serial Number Label - the serial number may be required during installation.
Control Button - press this button to install the camera using the AXIS Internet Dynamic DNS Service, or to restore the
factory default settings, as described in Resetting to the Factory Default Settings, on page 32.
Note:
AXIS Internet Dynamic DNS Service is free service from Axis that allows you to quickly and simply install your camera.
This requires an Internet connection with no HTTP proxy. See www.axiscam.net for more information.
LED indicators
LED Color Description
Network Green Steady for connection to 100 Mbit/s network. Flashes for network activity.
Amber Steady for connection to 10 Mbit/s network. Flashes for network activity.
Unlit No connection.
Status Green Shows steady green for normal operation.
Note: The Status LED can be configured to be unlit during normal operation, or to flash
only when the camera is accessed. See the online help files for more information. Go to
Setup > System Options > LED settings
Amber Steady during startup, reset to factory default or when restoring settings.
Red Slow flash for failed upgrade.
Power Green Normal operation.
Amber Flashes green/amber during firmware upgrade.