Lincoln Electric IM10070 Control Box CB-WCS - Manual (Page 10)

CONTROL BOX CB-WCS
2
Using this Instruction Manual
This instruction manual is intended to be used as a work of
reference for professional, well trained and authorized users
to be able to safely install, use, maintain and repair the
product mentioned on the cover of this document.
Always keep this manual with the product.
Pictograms and Symbols
The following pictograms and symbols are used in this
manual:
Service and Technical Support
For information about specific adjustments, maintenance or
repair jobs which are not dealt with in this manual, please
contact the supplier of the product. Make sure you have the
following data on hand:
- product name
- serial number
- purchase order (number + date) for warranty verification
The product name and serial number can be found on the
identification label located at the cover of the control box.
1.1 Identification of the Product
The identification label contains the following data:
• product name
• serial number
• supply voltage and frequency
• power consumption
1.2 General Description
The CB-WCS is a control box to:
• connect the automatic start/stop device WCS to the
mains
• switch the connected extraction fan SF 2400 on and off
by the automatic start/stop device WCS
The CB-WCS can also be used for connecting a stationary
welding fume extractor Statiflex 400-MS, an in the extraction
arm integrated Work Lamp (WL) and/or automatic start/stop
device (AST or WCS) and an extraction fan (SF 2400) to the
mains.
1.3 Product Combinations
The CB-WCS can be used with the following products:
• S23274-2
Welding cable sensor WCS
• K1656-1 Extraction fan SF 2400 (115V/1ph/60Hz)
1.4 Technical Specifications
Fig. 1.1: Dimensions
PREFACE
TIP
Suggestions and recommendations to simplify
carrying out tasks and actions.
ATTENTION!
Remark with additional information for the user. A
remark brings a possible problem to the user’s
attention.
CAUTION!
This statement appears where the instructions
must be followed to avoid minor personal injury
or damage to this equipment.
WARNING!
This statement appears where the instructions
must be followed exactly to avoid serious
personal injury or loss of life.
CAUTION!
Denotes risk of electric shock.
1 INTRODUCTION
CB-WCS
Product part # S-23271-1
Dimensions refer to Fig. 1.1
Weight 3.9 kg (8.6 lbs)
Isolation class IP 55
Operating temperature:
- minimum
- nominal
- maximum
- 5°C (41°F)
- 20°C (68°F)
- 45°C (113°F)
Max. relative humidity 80%