IEI Integration AFL2-12A-HM65 v1.12 - Manual (Page 50)

AFL2-12A-HM65 Series Panel PC
Page 36
Figure 4-11: The Rack/Cabinet Bracket
Step 2: Align the rack mounting bracket screw holes with the VESA mounting holes on
the rear of the panel PC.
Step 3: Secure the two rack mounting brackets to the rear of the panel PC by inserting
the four retention screws into the VESA mounting holes (Figure 4-10
n
).
Step 4: Insert the rack mounting clamps into the pre-formed holes along the two edges
of the rack mounting brackets (Figure 4-10
o
). There are a total of 4 rack
mounting clamps for the AFL2-12A-HM65.
Step 5: Tighten the screws that pass through the rack mounting clamps until the plastic
caps at the front of all the screws are firmly secured to the panel
(Figure 4-10
p
).