IEI Integration AFL2-12A-HM65 v1.12 - Manual (Page 46)

AFL2-12A-HM65 Series Panel PC
Page 32
4.8.1 Arm Mounting
The AFL2-12A-HM65 is VESA (Video Electronics Standards Association) compliant and
can be mounted on an arm with a 100mm interface pad. To mount the AFL2-12A-HM65
on an arm, please follow the steps below.
Step 1: The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.
NOTE:
When purchasing the arm please ensure that it is VESA compliant and that
the arm has a 100 mm interface pad. If the mounting arm is not VESA
compliant it cannot be used to support the AFL2-12A-HM65 flat bezel panel
PC.
Step 2: Once the mounting arm has been firmly attached to the surface, lift the flat bezel
panel PC onto the interface pad of the mounting arm.
Step 3: Align the retention screw holes on the mounting arm interface with those in the
flat bezel panel PC (
6
Figure 4-7).
Figure 4-7: Arm Mounting Retention Screw Holes