IEI Integration AFL-xxA-N270-Series v2.30 - Manual (Page 98)

AFL-xxA-N270 Series Panel PC
Page 82
NOTE:
Identical baud rate setting musts be set on the host (a management
computer running a terminal software) and the slave
Î Redirection After BIOS POST [Always]
Use the Redirection After BIOS POST option to specify when console redirection should
occur.
Î
Disabled The console is not redirected after POST
Î
Boot Loader Redirection is active during POST and during Boot
Loader
Î
Always D EFAULT
Redirection is always active (Some OSes may not
work if set to Always)
Î Terminal Type [ANSI]
Use the Terminal Type BIOS option to specify the remote terminal type.
Î
ANSI D EFAULT
The target terminal type is ANSI
Î
VT100 The target terminal type is VT100
Î
VT-UTF8 The target terminal type is VT-UTF8
6.3.7 USB Configuration
Use the USB Configuration menu to read USB configuration information and configure
the USB settings.