IEI Integration EBC-2102 - Manual (Page 4)

EBC-2102/2102W QIG IEI Technology Corp. Page 4
STEP 4: SYSTEM FAN INSTALLATION
(OPTIONAL)
To install the optional system fan, please follow the steps
below.
Step 1: Attach the system fan to the chassis, aligning the
retention screw holes on the system fan with the
retention screw holes on the chassis (Figure 5).
Figure 5: System Fan Installation
Step 2: Secure the system fan to the chassis by four
retention screws (Figure 6).
Figure 6: System Fan Retention Screws
Step 3: Once the motherboard is installed to the chassis,
connect the system fan cable to the system fan
connector on the motherboard. Please refer to
the user manual that came with the motherboard
for the connector location.
STEP 5: WI-FI MODULE INSTALLATION
(OPTIONAL)
To install the optional Wi-Fi module, please follow the steps
below.
Step 1: Turn the motherboard over. Locate the PCIe Mini
card socket.
Step 2: Insert the Wi-Fi module into the PCIe Mini socket
at an angle. To do this, line up the notch on the
Wi-Fi module with the notch on the connector.
Slide the Wi-Fi module into the socket at an angle
of about 20º.
Step 3: Push down until the card clips into place. Push
the other end of the card down until it clips into
place on the plastic connector.
Figure 7: Wi-Fi Module Installation
Step 4: Connect the Wi-Fi antenna cable from the
chassis to the Wi-Fi module.
Figure 8: Wi-Fi Antenna Cable Connection
STEP 6: MOTHERBOARD
INSTALLATION
To install a NANO-PV series motherboard, please follow the
instructions below:
Step 1: Place the motherboard inside the chassis. Make
sure the external peripheral interface connectors
fit into the predrilled holes on the rear of the
chassis.
Step 2: Align the four retention screw holes on the
motherboard with the retention screw holes on
the bottom of the chassis.
Step 3: Install the motherboard to the chassis with four
retention screws.
Figure 9: Motherboard Retention Screws