4 sata drive connection – IEI Integration IMBA-9454 v1.00 User Manual

Page 114

IMBA-9454 Motherboard

Page 96

Figure 5-11: Dual RS-232 Cable Installation

Step 3:

Secure the bracket. The dual RS-232 connector has two D-sub 9 male

connectors secured to a bracket. To secure the bracket to a chassis please refer

to the reference material that came with the chassis

Step 0:

5.6.4 SATA Drive Connection

The IMBA-9454 is shipped with SATA drive cables and SATA drive power cable. Follow

the steps below to connect the SATA drives to the motherboard.

Step 1:

Locate the connectors. The locations of the SATA drive connectors are shown

in Chapter 3.

Step 2:

Insert the cable connector. Press the clip on the connector at the end of the

SATA cable and insert the cable connector into the onboard SATA drive

connector. See Figure 5-12.