IEI Integration IMBA-9454 v1.00 - Manual (Page 111)

IMBA-9454 Motherboard
Page 93
5.4.3 COM2 Mode Selection
Jumper Label:
JP4
Jumper Type: 3-pin header
Jumper Settings: See Table 5-4
Jumper Location: See Figure 5-9
The COM2 Mode Selection jumper sets the communication protocol used by the second
serial communications port (COM 2) as RS-232, RS-422 or RS-485. The COM2 Mode
Selection settings are shown in Table 5-4.
Pins Description
Short 1-3 RS-232 Default
Short 3-5 RS-422/485
Table 5-4: COM2 Mode Selection Jumper Settings
5.5 Chassis Installation
5.5.1 Airflow
WARNING
Airflow is critical to the cooling of the CPU and other onboard
components. The chassis into which the IMBA-9454 is placed must
have air vents to allow proper airflow to cool the system components.
The IMBA-9454 must be installed in a chassis with ventilation holes on the sides allowing
airflow to travel over the heat sink surface. In a system with an individual power supply
unit, the cooling fan of a power supply can also help generate airflow over the board
surface.