IEI Integration KINO-AH611 - Manual (Page 68)

KINO-AH611
Page 56
Step 1: Locate the HDMI connector. The location of the HDMI connector is shown in
Chapter 3.
Step 2: Align the HDMI connector. Align the male HDMI connector on the digital
display device cable with the female HDMI connector on the external peripheral
interface.
Step 3: Insert the HDMI connector. Once the connectors are properly aligned with the
male connector, insert the male connector from the digital display device into the
female connector on the KINO-AH611.
Step 4: Secure the connector. Secure the HDMI connector from the digital display
device to the external interface by tightening the two retention screws on either
side of the connector.
4.6.3 LAN Connection
There are two external RJ-45 LAN connectors. The RJ-45 connector enables connection
to an external network. To connect a LAN cable with an RJ-45 connector, please follow
the instructions below.
Step 1: Locate the RJ-45 connectors. The location of the LAN connectors is shown in
Chapter 3.
Step 2: Align the connectors. Align the RJ-45 connector on the LAN cable with one of
the RJ-45 connectors on the KINO-AH611. See Figure 4-14.